Fluke 902 FC - Page 9

HVAC True-rms Clamp Meter
Safety Information
5
• Limit operation to the specified measurement
category, voltage, or amperage ratings.
• The battery door must be closed and locked be
fore
y
ou operate the Product.
• Remove all probes, test leads, and accessories befo
re
the
battery door is opened.
• Keep fingers behind the finger guards on the probes.
• Hold the Product behind the tactile barrier.
• Replace the batteries when the low battery indi
cator
sho
ws to prevent incorrect measurements.
• Do not use the HOLD function to measure unknow
n
pote
ntials. When HOLD is turned on, the display do
es
not
change when a different potential is measur
ed.
• Disco
nnect power and discharge all high-voltag
e
capacit
ors before you measure resistance, continuity,
capacitance, or a diode junction
.
• Remo
ve the input signals before you clean
the
Produc
t.
• Use only specified replacement parts.