Use the Product
Use a Profile in Sequence Mode 3
3-5
Edit a Profile
In Sequence mode, profiles can be edited during creation or during measurement.
Edit a Profile During Creation
To edit a profile during creation:
1. On the New Profile menu, use and L to highlight a data field to be edited.
2. Edit the data value.
a. For Device ID and Battery string, use the – and +.softkeys to change the value.
b. For other data fields, push the Edit softkey and use the arrow keys to change the
data value. Use the Select softkey for each selection and the Done softkey to
complete a data field.
3. Push the Start softkey to confirm the change and enter the measurement screen.
Modify a Profile During Measurement
To edit a profile during measurement:
1. Push the Profile softkey.
The Profile info screen shows.
Note
Once a profile is created, the battery number or the Start ID cannot be
changed. Other data values are editable.
2. Push the Modify softkey.
The Edit profile screen shows.
3. Use and L to highlight the data field to be edited.
4. Use the method in the “Edit a profile during creation” section to edit the profile.
Load a Profile
In Sequence mode, the Product can load a previously saved profile when it is switched
to Sequence mode or during measurements in Sequence mode. This method can be
used to continue an unfinished profile.
Note
All data in the current profile will be automatically saved when a
previous profile is loaded.
To Next Page
Loading...
Need help?
General
