EasyManuals Logo

Fluke BT520 User Manual

Fluke BT520
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Product Overview and Specifications
Safety Information 1
1-5
Safety Information
A Warning identifies conditions and procedures that are dangerous to the user. A
Caution identifies conditions and procedures that can cause damage to the Product or
the equipment under test.
Warning
To prevent possible electrical shock, fire, or personal injury:
Carefully read all instructions.
Read all safety information before you use the Product.
Use the Product only as specified, or the protection supplied
by the Product can be compromised.
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
Do not use the Product if it is damaged.
Do not use the Product if it operates incorrectly.
Do not apply more than the rated voltage, between the
terminals or between each terminal and earth ground.
Do not touch voltages > 30 V ac rms, 42 V ac peak, or 60 V dc.
Do not exceed the Measurement Category (CAT) rating of the
lowest rated individual component of a Product, probe, or
accessory.
Do not use the HOLD function to measure unknown potentials.
When HOLD is turned on, the display does not change when a
different potential is measured.
Use extreme caution when working around bare conductors or
bus bars. Contact with the conductor could result in electric
shock.
Do not use test leads if they are damaged. Examine the test
leads for damaged insulation or exposed metal, or if the wear
indicator shows. Check test lead continuity.
Connect the common test lead before the live test lead and
remove the live test lead before the common test lead.
Avoid simultaneous contact with battery and frame racks or
hardware that may be grounded.
Comply with local and national safety codes. Use personal
protective equipment (approved rubber gloves, face
protection, and flame-resistant clothes) to prevent shock and
arc blast injury where hazardous live conductors are exposed.
Examine the case before you use the Product. Look for cracks
or missing plastic. Carefully look at the insulation around the
terminals.

Table of Contents

Other manuals for Fluke BT520

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fluke BT520 and is the answer not in the manual?

Fluke BT520 Specifications

General IconGeneral
BrandFluke
ModelBT520
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals