Fluke ProcessMeter 787 - Page 37

Calibration Manual
Calibration
29
SEE THE "787 CALIBRATION MANUAL" FOR OPERATION
INSTRUCTIONS. THIS MODULE SHOULD BE OPERATED BY
QUALIFIED SERVICE AND CALIBRATION PERSONNEL ONLY.
787 CALIBRATION MODULE
787CAL
WARNING
Warning
TO AVOID ELECTRICAL SHOCK
FASTEN BATTERY DOOR TO MODEL 787 BEFORE CONNECTING TEST LEADS TO MODEL
787 OR OPERATING THIS CALIBRATION MODULE. REMOVE TEST LEADS FROM MODEL
787 INPUT JACKS BEFORE OPENING BATTERY DOOR. DISCONNECT FROM MODEL 787
BATTERY CABLE BEFORE OPENING CALIBRATION MODULE CASE.
FLUKE CORPORATION
MADE IN USA
RS-232 TO
COMPUTER
EXTERNAL
POWER SUPPLY
TO 787
BATTERY CLIP
BACK PANEL
Battery Eliminator
Cable
RS43 Cable 9-Pin
Null Modem Cable
SEE THE "787 CALIBRATION MANUAL" FOR OPERATION
INSTRUCTIONS. THIS MODULE SHOULD BE OPERATED BY
QUALIFIED SERVICE AND CALIBRATION PERSONNEL ONLY.
787 CALIBRATION MODULE
787CAL
WARNING
TO AVOID ELECTRICAL SHOCK
FASTEN BATTERY DOOR TO MODEL 787 BEFORE CONNECTING TEST LEADS TO MODEL
787 OR OPERATING THIS CALIBRATION MODULE. REMOVE TEST LEADS FROM MODEL
787 INPUT JACKS BEFORE OPENING BATTERY DOOR. DISCONNECT FROM MODEL 787
BATTERY CABLE BEFORE OPENING CALIBRATION MODULE CASE.
FLUKE CORPORATION
MADE IN USA
RS-232 TO
COMPUTER
EXTERNAL
POWER SUPPLY
TO 787
BATTERY CLIP
BACK PANEL
Battery Eliminator
Cable
RS43 Cable 9-Pin
Null Modem Cable
To PC To Outlet
1
4
2
3
5 6
Secure Battery Door to UUT.
Warning
Only use the battery
eliminator supplied
with the calibration
module (see Table 2).
Warning
Battery Door Must Secured to UUT.
LT011F.EPS
Figure 13. Connecting the 787 Calibration Module to the UUT