15
check your exhaust setup.
Operation Safety
1. Do not stare at the ame generated by the laser.
2. Stabilize the unit to prevent it from moving or overturning.
3. In case of burn injury, seek medical advice.
4. Wear gloves when cleaning leftover debris.
5. Have two people lift the unit when moving the machine.
Stop using your beamo if...
1. There is a re in the unit which persists after the laser
turns off.
2. The head stops moving but the laser is on.
3. An unusual sound or unusual light is coming from the unit.
4. You see any damage to the interior components of the
unit.
Conformity
The beamo unit is a Class 1 laser product containing an embed-
ded Class 4 CO2 laser and a Class 1 laser diode. Because the
Class 4 laser is fully contained in a Class 1 enclosure, this laser
product is designated as a Class 1 laser product during all proce-
dures of operation.
To Next Page
Loading...
