89
3. If the laser head doesn’t return to the rear left corner,
please use your phone or camera to make a video
including the whole work area (like the image in Step 1).
4. Start filming and repeat Step 1 and 2, send the video
to FLUX Support.
7.7 CAMERA ALIGNMENT ISSUE
1. Run camera calibration in software: Beam Studio >
Menu > Machines > Choose Machine > Calibrate
Camera. Make sure the height of the laser head is
adjusted to the right focus.
2. Compare the red-dotted-line square with the actual
square engraved, manually adjust the values to make
the 2 squares overlap.
7.8 CAMERA PREVIEW SPEED TOO SLOW
The preview results are formed by multiple snapshots
put together, if the loading speed is too slow, improving
the internet connection might help.
1. Go to software: Beam Studio > Menu > Machines >
Test Network Settings.
2. Fill in the Target device IP Address column with the
machine IP address.
To Next Page
Loading...
