86
7.2 CUT DIDN'T GO THROUGH
MATERIAL
1. Go to touchscreen > Maintain, make sure power is
set to "x1.0".
2. Check if the focus is adjusted at the right height.
3. Check if the lens or mirrors are dirty or damaged.
4. Check if the optical path is aligned.
5. If the solutions above didn’t work, please contact
FLUX Support.
7.3 #900 COOLER OFF
1. If you see a "#900 Cooler Off" dialog appears on the
touchscreen, press "Continue". If the error message
did not pop up again within one minute, the machine
should operate normally.
2. Check if the water level of the cooling tank is at least
half full.
To Next Page
Loading...
