85
7.1 NO LASER BEAM OUTPUT
If there is no laser beam output when beamo is running
and making a loud cracking sound, it indicates the tube
is broken. Please stop operating the machine to prevent
further hardware failure.
If you do not hear the cracking sound, please check the
following:
1. Go to touchscreen > Maintain, make sure the power
is set to "x1.0" then close the door. Press “Laser
Pulse” and observe from the laser observe hole if a
pinkish fluorescent light is emitted. If yes, it means
the laser tube is functioning, please proceed to
checking the optical path. If no pinkish fluorescent
light is observed, please contact FLUX Support.
To Next Page
Loading...
