TABLE OF CONTENTS
Troubleshooting
7.1 No Laser Beam Output.......................................85
7.2 Cut Did Not Go Through Material.............................86
7.3 #900 Cooler Off.........................................................86
7.4 #901 Door Opened....................................................87
7.5 #902 Overheated.......................................................88
7.6 Laser Head Did Not Return To Rear Left Corner........88
7.7 Camera Alignment Issue............................................89
7.8 Camera Preview Speed Too Slow..............................89
7.9 Camera Preview Does Not Work...............................90
7.10 Connection Issue......................................................90
7.11 Software Quits Unexpectedly...................................94
Addtional Information
8.1 Technical Data............................................................96
8.2 Storage and Transport................................................96
8.3 FLUX Support.............................................................97
8.4 Disassembling & Dismantling................................97
To Next Page
Loading...
