Set support modes
You can set the level of support using operating
unit 12 (Ill. page 10). The following levels are
available (the selection may be restricted, de
-
pending on the version).
• OFF: No motor support; you are pedalling
your FLYER like a normal cycle. All on-board
computer functions can be called up.
• ECO: Effective electrical support with maxi
-
mum efciency to achieve maximum range.
• TOUR: Even support for touring over a wide
range.
• SPORT: Powerful, direct support for sporty ri
-
ding off-road and in urban trafc.
• TURBO: Maximum support level for sporty ri
-
ding up to high pedalling cadences.
Use the "+" button on operating unit 12 (Ill. page
10) to switch to the next higher support level, and
the "-" button to move down to a lower level. Hold
the button down until you are in the desired sup
-
port level.
The battery charge status display for your
FLYER battery can be displayed in "Ride" (r9)
operating mode or with status display (s7). Each
of the bars in the display corresponds to around
20% of capacity.
The battery is fully charged.
The battery should be topped up.
There is no longer sufcient energy
available for drive system support and
support will be gradually decreased. The
remaining energy is being used for the
cycle lighting and the on-board com
-
puter.
The Nyon has not yet been put in its
holder or it has been reset to its factory
settings.
Nyon has its own battery. The charge status for
this can be seen in display (s1).
Power supply
If your Nyon is in its holder on your FLYER, it is
being supplied with power from the sufciently
charged battery on your FLYER e-bike. If your
Nyon is not in its holder it draws its power from its
own Nyon battery. Further details of how the Nyon
battery is charged can be read in the enclosed
drive manufacturer's operating manual.
The pushing aid/start-up aid is switched on and
off with the "Walk" button 17.
The cycle lights can be switched on and off with
button 6 . The lighting symbol (s1) appears when
the lighting is switched on.
If a fault should occur in the eBike system com
-
ponents, an error code appears in the display.
In addition, please read the original instruction
manual to the Bosch Drive Unit / Nyon enclosed.
If an error code should appear, have the
system examined by an authorised
FLYER dealer and repaired if necessary.
Nylon reset
By pressing buttons 1, 2, 5 and 6 simultaneously,
you can reset your Nyon if it is no longer respond
-
ing. However, you should be aware that this may
result in many settings being lost.
The option is available of extending the standard
functions of the "Nyon" operating system by pur
-
chasing "Premium" functions.
To Next Page
Loading...
Need help?
General
