132
8. Before the rst ride
Ensure that the e-bike is ready for use
and adjusted to t your body.
This includes:
• Setting the position and xture of the seat and
handlebars
• Adjusting the brakes
• Securing the wheels into the frame and fork
To ensure that you enjoy a safe and comfortable
riding position, please allow your FLYER special
-
ist retailer to set up your handlebars and stem.
Have the saddle set to a safe and comfortable
position (see Chapter 11.2.).
Have the brake handles set by the FLYER spe
-
cialist retailer so that you can reach them easily
at all times and can use the brake without getting
tired. Be sure to familiarize yourself with the brake
levers connected to the front and back wheels –
the left brake lever is usually for the front wheel
and the right lever is usually for the back one!
Despite this general rule, however, you should
still check what wheels the brakes are connected
to since this standard isn't always followed.
Before each ride, and anytime your bike has
been left unattended for a short period of time,
make sure to check if each screw, quick-release
lever, thru axel or other important components
are properly secured where they belong. A table
listing the most important screw connections and
the prescribed fastening torques is provided in
Chapter 20.2, while notes on the correct use of
quick release fasteners and quick release axles
are provided in Chapter 11.1.
When you are driving with clipless/step-in pedals:
Functional testing is required. The pedals should
release easily and smoothly.
Check the tyre pressure. The manufacturer guide
-
lines which may not be exceeded or undercut are
printed on the side of the tyres. Do not exceed
either the stipulated maximum pressure or drop
below the stipulated minimum pressure. General
comments: Lower air pressure gives greater trac
-
tion and comfort, while higher air pressure reduc-
es resistance and extends range.
Example of tyre pressure information
It is also necessary for you to check the following
components of your FLYER e-bike:
• Please check that the battery is secure.
• Check the charging state of the battery to en
-
sure that the charge is sufcient for the drive
planned.
• Familiarise yourself with the functions of the
operating element.
Familiarize yourself with your
new FLYER e-bike’s riding and handling
performance by testing its features out in
a safe and quiet area.
1. Only use a FLYER with a frame size that
suits you. Ensure that your legs have
enough room to manoeuvre. You
must be able to dismount quickly with
-
out touching the frame. Insufcient
clearance or room to manoeuvre may
lead to severe injuries.
2. Please note that while preparing to
mount your FLYER that it will imme
-
diately start moving as soon as you
put your foot onto the pedal when the
support mode is switched on. Do not
place your foot on the pedal when
mounting. Hold the brake, as the
unfamiliar thrust may otherwise lead
to falls or other accidents. Stand to
one side of the FLYER and lift your
leg over the e-bike. Firmly hold the
handle bars with both hands, as you
would do with a bicycle.
3. Modern brakes have a substantially
higher braking performance than con
-
ventional brakes. Carefully practise
using your brakes. Note that in wet
conditions and on slippery roads, your
bike’s braking power, especially when
using rim brakes, is severely reduced.
Expect a longer braking distance if
you are riding in wet conditions. Look
ahead while riding and familiarise
yourself with the brakes' response
time.
To Next Page
Loading...
Need help?
General
