146 147
EN
Separate the battery from the charger and wait
until it has reached operating temperature. Only
reconnect the charger when it has reached the
permitted operating temperature.
The charging time increases when the
battery temperature is very low.
• Prevent extreme overheating due to
external effects or overloading.
• Only use the battery with your FLYER.
• Never use a damaged battery. If you
discover cracks, deformation of the
housing or leaks, stop using the bat-
tery and have your FLYER checked
by a specialist retailer.
• The lighting function will still continue
for approx. one hour after the battery
is empty.
5.4 Inserting and removing the
battery
Switch off the battery whenever you in-
sert it into its holder or remove it from its
holder.
A5
A6
A7
7°
A8
A9
Insert the standard battery A8 by placing it with
its contacts pointing downwards into the lower
holder A9 of the e-bike (the battery may have an
incline of up to 7° towards the frame). Place it in
the top holder at a tilt A7. Check whether the bat-
tery is rmly attached.
Always secure the battery lock as it might other-
wise release the battery and allow it to fall out of
the holder.
Always remove the key A5 from the lock A6 after
locking. This prevents the key from falling out and
also prevents unauthorised removal of the battery
by third parties while the e-bike is parked.
To remove the standard battery A8, switch it off
and open the lock with the key A5. Tilt the battery
out of the top holder A7 and pull it out of the bot-
tom holder A9.
To insert the power tube battery A2, place it on
the e-bike with its contacts on the lower holder
A5. Tilt it into the upper holder A7 until it reaches
the limit stop and audibly clicks in. The battery is
only xed in the upper holder once this is done.
Check that the battery is rmly in place.
Always remove the key A5 from the lock A6 after
closing. This prevents the key from falling out or
the battery being removed by a third party when
the e-bike is parked. To remove the power tube
battery A2, switch it off. Open the lock with the
key A5. Tilt the battery out of the upper holder A7
and pull it out of the lower holder A9.
To Next Page
Loading...
