174 175
EN
• Check that the handlebars, stem, seat post
and seat are safely attached and correctly po
-
sitioned
• Check the battery's charge status
• Check that the battery is correctly and securely
attached.
After each ride
FLYER driver:
• Cleaning the FLYER e-bike
• Visual inspection of the frame and of compo
-
nents for cracks and damage
• Check the tyres for damage, wear, brittleness,
alien objects and sufcient prole depth
• Check the rims for wear and true running
• Check the tension of the spokes
• Clean the chain and sprockets as required
and lubricate them with a suitable chain oil ap
-
proved by the manufacturer
• Clean the rims or brake discs as required with
a suitable brake cleaner approved by the man
-
ufacturer
• Clean all bearings as required and lubricate
them with suitable lubricant approved by the
manufacturer
• Clean suspension elements as required and
lubricate them with original lubricant approved
by the suspension manufacturer
• Clean all moving parts for which lubrication is
intended (in particular quick release fasteners
and joints) as required and lubricate them with
a suitable lubricant approved by the manufac
-
turer
Allow your FLYER specialist retailer to instruct
you.
What to do after riding in rain, snow
or wet conditions:
(in addition to the points under “After each drive”)
FLYER driver:
• Clean the chain and lubricate it with a suitable
lubricant approved by the manufacturer
• Clean the brake
• Clean the gear system
• Check the sufcient lubrication of all compo
-
nents
Allow your FLYER specialist retailer to instruct
you.
Monthly
FLYER driver:
Check the rm attachment of all screws, nuts and
quick release fasteners
Every year or after every 1,000 km,
whichever occurs rst
FLYER specialist retailer:
• Lubrication of all moving parts for which lubri
-
cation is intended (excluding brake surfaces)
• Visual inspection of the frame and of compo
-
nents for cracks and damage
• Mend paint damage
• Replace parts with rust spots
• Treat all bare metal parts (excluding brake sur
-
faces) against corrosion (rust)
• Change defective or damaged parts
• Check the wheels and centre them as required
• Check the tension of the spokes
• Check and clean the chain/sprocket/cogset
• Lubricate the chain with a suitable lubricant
• Check the rim for wear
• Check the brake pads and brake blocks for wear
• Check all screws, nuts and quick release fas
-
teners for rm attachment
• Check the brake system and adjust it or re
-
place parts if necessary
• Check the gear system and adjust or replace
parts of it if necessary
• Check the hubs
• Check the headset
• Check the pedals
Only use cleaning agents and lubricants
that are recommended or approved by
the component manufacturer.
Please note that not all lubricants and
care products are suitable for your
FLYER. By using unsuitable lubricants or
care products, you can damage or impact
the functionality of your FLYER e-bike.
Ensure that the brake pads, brake discs
and brake surfaces are not exposed to
cleaning or servicing uids or oils, as this
reduces the performance of the brakes.
22.1 Maintenance work and
exchange of wearing parts
Components to be changed may only be
replaced with identical, original parts.
Wearing parts may only be replaced with
identical, original components.
Using any parts other than the original
ones will immediately cause the manu
-
facturer’s liability for material defects
and/ or the manufacturer’s warranty ser
-
vice to become void. There is also an
increased risk of accidents or falls.
To Next Page
Loading...
