Flyer UPROC - Adjusting the bike to the rider; Installing pedals

32
1. All quick release skewers must be
rmlyclosedbeforeyouseto󰀨.
2. Check all quick release fasteners for
correct attachment if the vehicle was
parked even for a short time without
supervision and before every ride.
3. A closed quick release fastener must
be folded close to the frame, fork or
seat post.
Lock down wheels or other parts of your
vehicle that are attached with quick re-
lease fasteners when you park your bi-
cycle.
Quick
releaseaxles
The current chassis is either equipped with quick
release fasteners, screw connectors or quick re
-
lease
axlesthat workinthesamewayasquick
release fasteners:
Theaxle is screwed into the dropoutandholds
the hub between the fork legs. The hub and the
axlearefastenedwithaquickreleaselever.Sys
-
tems
inwhichtheaxleisonlyinsertedorscrewed
in and then fastened with a screw also exist.
Refer to the attached component manufacturer
instructions and allow your FLYER specialist re
-
tailer
toexplainthesystemtoyouindetail.
Ask your FLYER specialist retailer to
explainindetailhowthewheelsandall
relevant parts are to be correctly and
safely attached using the quick release
fastener or quick release axle system
installed. .