• The firmware updating software according the operating system (Flymaster firmware
installer).
The first step of the updating procedure consists in installing the USB drivers. In order to
do that you should run the drivers installation file and follow the on-screen instructions.
Next you need to install the update application, run the Flymaster firmware installer setup
and follow the on-screen instructions.
Once the driver and the update tool are correctly installed do the following procedure.
1. Double click the firmware file, this will start the Flymaster Firmware installer, with the
firmware path already inserted. Alternatively, open the Firmware installer, and insert the
path to the firmware file. (see Figure. 20)
2. Click “Send Firmware” button. The message “waiting for Flymaster intrument...” will
apear.
3. Connect the VARIO to the PC using the cable supplied. If it is the first time the VARIO
is connected to the PC, wait until Windows show the message that new hardware is
present a ready to use.
4. The update should start automatic, and a message appears saying “Programing...”, and a
progress bar starts to grow. If after a few seconds nothing happens reset the VARIO(click
at the same time the Menu and down arrow key for 2 seconds (see section 3.5 )).
When the process is finish the application shows a message saying “complete”. Then
disconnect the USB cable and the VARIO will start to work. Eventually, a message can
appear asking for a Layout. If this happens the Designer software should be used to
upload a new layout.
Document version: 2.0 Page 26
To Next Page
Loading...
