FMUser RDS-C - Page 26

FMUSER INTERNATIONAL GROUP INC. 广州市汉婷生物技术开发有限公司
25
DPS1REP Dynamic PS 1 Number of Repeating (0-127),[CLR]
Specifies number of repeating for the DPS1 text message. Optionally the DPS1 text is then cleared.
Without the optional CLR parameter specified the command has effect only if DPS2 is set.
Number of repeating = number of transmissions
-
1.
DPS1REP=1
DPS1REP=2,CLR
DPS2REP
Dynamic PS 2 Number of Repeating
(0
-
255)
Specifies number of repeating for the DPS2 text message. Has effect only if DPS1 is set or if DPS2MSG value
is AUTO.
Number of repeating = number of transmissions - 1.
DPS2REP=0
DTTMOUT
Default Text Timeout
(0
-
254)
Specifies a timeout in minutes for Radiotext 1. If no RT1 has been received during the period, the RT1 text
is replaced by default text. If RT+ service is active, the RT+ running bit is cleared.
Default text means the RT1 text that is stored in EEPROM memory using *RT1.
1-254 – Timeout in minutes.
0 – Function disabled.
DTTMOUT=10
EQTEXT1
Equal Text 1
(0, 1)
If set to 1, any update of RT1 updates also DPS1 and vice versa. Does not apply to UECP control.
EQTEXT1=1
DPS1=Hello World
RT1
L
ABPER
Label Period
(0
-
255)
Label Period used in DPS Mode 0 and 2. Increasing the value by 1 increases the period by approx. 0.54
seconds (exact value depends on Group Sequence).
LABPER=4
Each label is displayed for about 2 seconds.
MS
Musi
c/Speech
(0, 1)
Music/Speech switch.
MS=0
Speech program
MS=1
Music program
PI
Program Identification
H (1000
-
FFFF)
Identification code of the radio station. Always contains four hexadecimal digits.
PI=20FE
OK
PI=0F55
Not allowed (0 as first digit)
PS
Program Service name
Static name of radio station that is displayed on receiver. Max. 8 characters long.
The PS= command requires additional processing time of up to 400 ms for internal synchronization with RDS
group order.
PS=KISS FM