What to do if FMUser RDS-C does not communicate with PC and LED doesn't indicate data receive?
If the FMUser Media Converter isn't communicating with your PC and the LED doesn't show data reception, ensure all connectors are fully seated and secured with screws where possible. Also, verify that you've selected the correct COM port in the options or preferences list.
Why is there no RDS output from my FMUser RDS-C Media Converter, even though the LED indicates operation?
If you're experiencing no RDS output from your FMUser Media Converter but the LED indicates it's running, check if the RDS output is connected to the correct input on the transmitter. You might need to adjust the RDS level higher or increase the input sensitivity on the transmitter. Also, ensure the RDS generator is switched on, which can be done via Options – Special – Switch on RDS RDSGEN=1.
General| Brand | FMUser |
|---|---|
| Model | RDS-C |
| Category | Media Converter |
| Language | English |
Configuration options using jumpers on the RDS encoder board.
Details on power requirements and connections for the RDS encoder.
Procedures for adjusting signal levels and phase for optimal performance.
Configuration of fundamental RDS parameters including Program Identification (PI).
Initial setup and usage guide for the Windows control software.
Physical connection steps for RS-232 communication with a PC.
Using terminal software for RDS encoder configuration and control.
Understanding and using the RDS encoder's command interpreter.
Comprehensive list and description of all available commands.
Details on fundamental commands for RDS services like AF, DI, DPS1, DPS2.
Guide to diagnosing and resolving common problems with the RDS encoder.
To Next Page