FMUser RDS-C - 11.9 Dynamic PS 1 and Dynamic PS 2 Summary

FMUSER INTERNATIONAL GROUP INC. 广州市汉婷生物技术开发有限公司
39
UECP UECP Enable
(0, 1)
Enables (1) or disables (0) the UECP support. ASCII commands are accepted regardless of this
value. Disabled by default.
UECP=1
> Assign Last Value
This command is useful for ASCII terminal control. It allows to handover texts between most commands or
services. See the examples below.
If the last value is empty or not available (cleared by launching a Scheduling or CC item), nothing will happen.
This command is not recommended for automated processing.
PS=RADIO
88
Sets the ‘RADIO 88’ program service name
>TPS
and uses the same name also for Traffic PS
MSG01
Shows the Message 01 text
>*MSG02
and copies it to Message 02
DPS1
Shows the Dynamic PS 1 text
>RT2
and copies it to Radiotext 2