FoamPRO 2002 Series - Page 6

6
Installation and Operation ManualInstallation and Operation Manual
SYSTEM ACCESSORIES AVAILABLE
FoamPro MultiFlo Interface
Combines 2 to 4 flowmeters
for single point systems
System Placard
Solid State Contactor
P/N 2510-0043
Nesconset, NY 11767 US
A
Main Waterway Check Valve with Drain Port
Available in stainless steel or nickel plated steel,
NPT threaded ends with injection and drain ports
System
Specification Placards
Remote Start/Stop
Polypropylene Foam Tank(s)
8, 12 or 20 gallon capacity
Foam Manifold
All stainless steel with main waterway
check valve, water flowmeter, injection
port, and drain port. Victaulic grooved ends
For more information on these accessories, please see publications 856 and PL-21.
Manual Concentrate
Management System
Manual control for Dual Tank
Systems with interface
to controller
Electronic Concentrate
Management System
Electronic control for Dual Tank Systems
with interface to controller
Electronic Concentrate Management System
Electronic control of single or dual tank onboard
systems and an off-board pickup.
2002 Series and larger only
Main Waterway Check Valve
All stainless steel with Victaulic
ends and injection and drain ports
NFPA Calibration and Test Kit
For use with 1600 thru 3012 systems
Dual Injection Management System
Provides capability for switching between
two injection points
CAFS Power-Link
Interfaces FoamPro system with CAF system
Single Tank Flush Kits
Both Internal and External flushing kits