Quick Start
FS-T1001 Media Recorder -
13
When timecode stops, the recording stops.
NOTE: When this mode is being used, before connecting
FS-T1001 to the camera, make sure the camera is set to
REC-RUN mode and not recording.
Set Record Mode
Two REC MODE options are available:
•
NORMAL - In normal record mode, FS-T1001 begins
recording immediately when triggered.
•
RETRO CACHE - Retro Cache mode continuously records
a constant video loop in the FS-T1001’s flash RAM. The
length of the video loop can be preset in one-second
intervals, up to 10 seconds. Once record is triggered, the
cached content is added to the beginning of the recording.
See SETUP for presetting the desired retro cache duration.
Set Record Format Mode
Two REC FORMAT options are available:
•
HQ MODE - Sets the record bit rate to 35Mb/s (MP@HL)
recording mode in the XDCAM EX format.
•
SP MODE - Sets the record bit rate to 25Mb/s (MP@H-14)
recording mode in the XDCAM EX format.
Set 1080i Frame Size (HQ Mode Only)
Two HQ 1080i options are available:
•
1440 - Sets the HQ (35Mb/s) frame size to 1440x1080
•
1920 - Sets the HQ (35Mb/s) frame size to 1920x1080
Set Timecode Mode
Four TIMECODE options are available:
•
EXTERNAL - The timecode recorded comes from the
RP188 timecode in the HD-SDI input stream (Default TC
display mode)
•
FREE RUN - The timecode recorded comes from the
internal, constantly incrementing free run timecode
generator in the FS-T1001. It is possible to set the TC
value using the TC Set function in the setup menu.
To Next Page
Loading...
