Quick Start
- FS-T1001 Media Recorder
14
• REC-RUN - The timecode recorded comes from the
internal timecode generator in FS-T1001. Timecode only
increments when a recording is in process.
The first frame of a new recording will have a TC value +1
from the previous recording.
•
REGEN - The timecode recorded comes from the internal
timecode generator on FS-T1001. Timecode only
increments when a recording is in process. The first frame
of a new recording will have a TC value +1 from the last
recording on the media.
FREE-RUN, REC-RUN and REGEN record modes ignore the
RP-188 timecode in the incoming HD-SDI stream. These
modes are useful when the RP-188 timecode in the HD-SDI
stream is not desired or the source does not support RP-188
timecode.
Set Audio Mode
There are three AUDIO options:
•
Ch 1/2 - When 2-channel audio recording is desired, this
setting records channels 1 and 2 of the embedded SDI
audio input.
•
Ch 3/4 - When 2-channel audio recording is desired, this
setting records channels 3 and 4 of the embedded SDI
audio input.
•
Ch 1/2/3/4 - When 4-channel audio recording is desired,
this setting records channels 1, 2, 3 and 4 of the embedded
SDI audio input. NOTE: 4-channel audio is for use with
HQ modes only.
To Next Page
Loading...
