Analogue Fader & CUT Automation
Control 2802 Logic Pro Automation & Control Surface Manual 25
Analogue Fader & CUT Automation
HUI
TM
/ MIDI automation from your DAW can be applied to Control 2802’s analogue channel levels and motorised faders. This allows
you to automate the faders and CUTs of the 8 analogue main channel paths - ideal if you wish to sum using the analogue mix bus, but
still have automated control.
CUTs as well as faders can be automated - this is ideal for muting analogue channels (with inserts) during quiet sections
of the mix, and thereby reducing any unwanted noise from vintage outboard.
The analogue automation works along side the full DAW control surface layer. This means that fader and cut automation
can be written and replayed on both the DAW and anaogue fader layers.
The diagram below provides an overview of the analogue automation system and the parameters that can be controlled:
The sections of most interest when using the analogue
automation are:
● Faders
● CUT switches
● AUTO MODE and AUTO SAFE SELECT MODEs
● DAW Transport Control
To Next Page
Loading...
Need help?
General
