Checking windshield washer fluid
To check the windshield washer fluid level:
1. Unlock and
remove the
hood.
2. Observe the
level of fluid in
the reservoir on
the right side of
the
compartment.
3. If necessary, unscrew the reservoir cap and fill
with pre-mixed washer fluid.
4. Install the reservoir cap.
5. Install and lock the hood.
Checking the wiper blade
If the wiper operation results in streaky or
obstructed vision, clean the blade with mild soap
and water to remove any foreign material, grease or
dirt. If the wiper operation still results in poor
visibility, inspect the blade, the insert, and the arm.
• Confirm that the arm and blade are not bent or
damaged. If any defect is found, the part must be
replaced to assure proper operation.
• Confirm that the wiper blade insert is supple and
pliable. If it has become hard, cracked, or split it
must be replaced for proper operation.
Driver controls
24
To Next Page
Loading...