Caution: Do not allow the vehicle to remain in
a discharged state, as batteries may be
permanently damaged and vehicle range will be
decreased.
To recharge your vehicle batteries:
Use only the GFCI cord supplied with the vehicle. If
the GFCI cord does not fit the receptacle, have a
qualified electrician install the proper outlet.
Note: The outlet must be properly installed and
grounded in accordance with all local codes and
ordinances.
1. Park your vehicle within GFCI charger cord length
of a 120 volt AC 15A grounded 3-prong wall outlet.
2. Place the drive mode selector switch in the OFF
position, remove the key and set the parking brake.
Note: Make sure the power point (if equipped) is
not in use.
Note: Make sure that the inlet is clean and dry.
Note: Never use a plug adapter or an extension
cord.
3. Insert the male end of the GFCI charger cord in a
120 volt AC grounded receptacle. Verify that the
power indicator light on the GFCI cord is on.
4. Open the
charge inlet
access door.
Charging
70
To Next Page
Loading...
Need help?
General