HAZARD FLASHER SWITCH
Use the hazard
flashers only in
an emergency
to warn traffic
of your vehicle
breakdown, or
approaching
danger, etc. The
hazard flashers
can be operated
with the drive
mode selector switch in all positions. The hazard
flasher switch is located on top of the steering
column, right behind the steering wheel. Depress the
switch to activate the hazard lights. To turn off the
hazard lights, depress the switch again.
With the hazard
flasher switch
depressed, both
turn signal indicators will flash on the instrument
panel cluster.
12V FUSES
Change a fuse
If electrical components
are not working, check
the circuit fuse first to
see if it is blown. You
can identify a blown fuse
by the broken wire in the center of the fuse between
two prongs.
Always replace a fuse with one that has the
specified amperage rating. Using a fuse with
a higher amperage rating can cause severe wire
damage and could start a fire.
15
Roadside emergencies
75
To Next Page
Loading...
Need help?
General