Perform the following steps to install a
child safety seat with tether anchors:
Note: If you install a child seat with rigid
LATCH attachments, do not tighten the
tether strap enough to lift the child seat off
your vehicle seat cushion when the child is
seated in it. Keep the tether strap just snug
without lifting the front of the child seat.
Keeping the child seat just touching your
vehicle seat gives the best protection in a
severe crash.
Second row
1. Route the child safety seat tether strap
over the back of the seat. For the
second row outboard seating positions,
route the tether strap under the head
restraint and between the head
restraint posts. For the second row
center seating position, route the tether
strap over the top of the head restraint.
If needed, the head restraints can also
be removed.
2. Locate the correct anchor on the back
panel of the rear seat for the selected
seating position. The anchors are
labeled with the tether strap symbol
and are partially covered by the gap
panel. Pull the panel back to fully
expose the anchors.
3. Clip the tether strap to the anchor as
shown.
4. Tighten the child safety seat tether
strap according to the manufacturer's
instructions. If your child restraint
system is equipped with a tether strap,
and the child restraint manufacturer
recommends its use, we also
recommend its use.
22
Tourneo Connect/Transit Connect (CHC) Canada/United States of America, enUSA, First Printing
Child Safety
To Next Page
Loading...
Need help?
General
