WHAT IS TRAIL CONTROL
WARNING: The system does not
control speed in low traction conditions
or extremely steep slopes. The system
is designed to be an aid and does not
relieve you of your responsibility to drive
with due care and attention. Failure to
follow this instruction could result in
personal injury.
Trail control lets you focus on steering
during low-speed and off-road use by
controlling your vehicle's acceleration and
braking to maintain the speed that you set.
You may hear a noise from the anti-lock
brake system pump motor when you use
the system. This is normal.
TRAIL CONTROL LIMITATIONS
Trail control is unavailable when any of the
following occur:
• Your vehicle speed is greater than
20 mph (32 km/h) in two-wheel drive
high or four-wheel drive high modes.
• Your vehicle speed is greater than
9 mph (15 km/h) in four-wheel drive
low mode.
• Your vehicle speed is greater than
3 mph (5 km/h) in reverse (R).
• The transmission is in park (P).
• The driver side door is open or your
seatbelt is off when the driver side door
is removed.
• Cruise control is on.
• Pro trailer backup assist is on.
SWITCHING TRAIL CONTROL
ON AND OFF
Press the button on the center console.
Note: If your vehicle is equipped with trail
one pedal drive, this will activate trail one
pedal drive if you are in four wheel drive high
or four wheel drive low mode, until you set
a speed for trail control.
The system switches off if you press the
button again or exceed 40 mph (64 km/h).
SETTING THE TRAIL CONTROL
SPEED
Note: The buttons are on the steering
wheel.
Drive to the speed you prefer.
Press the button to set or
increase the set speed. Press
and hold to adjust the speed in
larger increments.
Press the button to set or
decrease the set speed. Press
and hold to adjust the speed in
larger increments.
Note: The indicator changes color.
207
2021 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202101, First-Printing
Trail Control (If Equipped)
To Next Page
Loading...
