Ford Bronco 2021 - Storing the Roof Panels - 2-Door

STORING THE ROOF PANELS
- 2-DOOR (IF EQUIPPED)
WARNING: Do not store removed
doors or roof panels in vehicle without
using the Ford onboard storage kit, and
verifying they have been secured per
instructions. Failure to follow this
instruction could result in personal injury
or death.
Note: The two-door vehicle is not capable
of on board storage of the doors. Store the
doors in a secure area to avoid damage.
Note: Roof panels should be clean prior to
storage in bags as dirt may damage the
finish.
1. Remove the front roof panels. See
Removing and Installing the Front
Roof Panel (page 343).
E338782
2. Open the bag and pull out the divider.
Place the first panel into the bag.
Replace the divider before placing the
second panel into the bag.
3. Zip the bag closed.
4. Gently slide the roof panel bag into the
cargo area in the vertical position.
5. Secure the upper roof bag strap around
the rear seat headrests. Adjust the
tension on the straps until it is snug.
Note: Do not over-tighten the strap. This
may cause damage to the headrest.
E347721
6. Secure the lower bag hooks to the
forward cargo rings.
359
2021 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202101, First-Printing
Removable Vehicle Components