3. Lift the rear of the soft top and support
it with the soft top strut.
REMOVING AND INSTALLING THE
SOFT TOP
WARNING: When opening, closing,
removing or installing the removable
vehicle components, take care not to get
your fingers or hands caught in the
mechanism. Failure to follow this
instruction could result in personal injury.
1. Fully open the soft top. See Opening
and Closing the Soft Top (page 348).
2. Remove the three fasteners on each
side in the rear cargo area using the
provided head driver and ratchet.
3. Remove the soft top.
Note: Safely store the soft top when it is
off your vehicle.
4. To install, reverse the removal
procedure. Torque the fasteners that
secure soft top to the vehicle to
15 ± 2 lb.ft (20 ± 3 Nm).
Note: Make sure the soft top is set flush on
the locating pins.
Note: Do not overtighten the fasteners. You
can strip the fasteners if they are
overtightened.
Installing the Soft Top Trim Piece
(If Equipped)
Make sure to install the soft top trim pieces
before installing the soft top.
350
2021 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202101, First-Printing
Removable Vehicle Components
To Next Page
Loading...
