Press the button on the
touchscreen.
2. Press Vehicle.
3. Press Wipers.
4. Switch Rain Sensing on or off.
Note: When you switch the feature off, the
wipers do not operate based on the rain
sensor. When you switch on the windshield
wipers to the intermittent wipe position with
the feature off, the wipers use the wipe
speed set by the rotary control.
ADJUSTING THE SENSITIVITY OF
THE RAIN SENSOR
High sensitivity.A
Low sensitivity.B
Use the rotary control to set the rain sensor
sensitivity.
When you select high sensitivity, the wipers
operate when the sensor detects a small
amount of water on the windshield.
When you select low sensitivity, the wipers
operate when the sensor detects a large
amount of water on the windshield.
CHECKING THE WIPER
BLADES
Run the tip of your fingers over the edge of
the blade to check for roughness.
REPLACING THE FRONT
WIPER BLADES
Make sure your vehicle is off before
beginning this procedure.
Note: Do not manually move the wiper
arms. To place the wiper arms in a service
position, switch your vehicle on in accessory
mode, switch on the wipers and switch your
vehicle off when the wipers are at their
highest position.
93
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Wipers and Washers
To Next Page
Loading...
Need help?
General
