36
Optional extras
The following items can be purchased for your 508 vacuum forming machine:
1. Service kit 2. Reducing windows 3. Blow mould windows
4. 508DT Machine trolley 5. 508FS cooling fan
& gantry
1. It is unlikely that you will need to service or repair your machine for many years provided you follow
the maintenance information contained in this manual. However, the table and clamp seals, which are
considered to be consumable items, will need to be replaced depending on the usage of the machine.
Therefore this kit contains the essential consumables (seals and pump filter) to ensure a good performance
of your machine year on year.
2. Formech has available 2 standard sizes of reducing windows for the 508, with apertures of 228 x 204mm
and 432 x 229 mm. Formech can also produce special size reducing windows. For more information please
contact our sales department. See page 13 for installation.
3. You can use your vacuum forming machine to do blow moulding by fitting a special circular reducing
window to your machine. The maximum diameter you will get on the 508FS is 430mm. For more
information please contact our sales department.
4. The Formech trolley allows you to easily move your 508DT machine. The 2 locking castors assure the
trolley remains in position all the time. Underneath there is also space to store plastic material and moulds.
The size of the trolley is the following - depth: 780mm, height: 720mm, width: 608mm
5. Overhead gantry and single 125W fan to cool formed material and shorten cycles times.
To Next Page
Loading...
