Formlabs Form 4B - Glossary

Glossary | 51
11. Glossary
Term Meaning
Backlight Unit A set of 405 nm LEDs emit light upwards through lenses, the
Light Processing Unit, and the bottom of the resin tank to cure
liquid resin.
Bite valve A flexible, rubber seal that regulates resin dispensing. Resin
flows out when the cartridge dispense arm squeezes the bite
valve open.
Build platform–see also, platform
lock
The aluminum base provides a surface for prints to attach to. Over
time, the build platform develops scratches from part removal,
which can assist with print adherence.
Build platform mount The metal arm that the build platform slides onto.
Build platform jig Stabilize the build platform for the secure removal of prints.
Secure the build platform jig to the edge of your work surface by
tightening the jig screw clamps underneath the work surface.
Build platform latch A lever that is part of the locking mechanism that secures the build
platform. Contact Formlabs Support or a certified service provider
before adjusting the platform lock, as improper adjustment can
damage the machine.
Build platform sensor Each Form4B build platform has an RFID sticker. The printer
senses the RFID sticker to detect when the build platform is
properly installed.
Cartridge dispense arm Plastic hooks press against the bite valve to dispense resin out of
the resin cartridge into the resin tank.
Cartridge RFID sticker Each resin cartridge has an RFID sticker attached to the cartridge
skirt. The printer reads the RFID sticker to detect the unique
cartridge ID and resin type.
Cleaning sheet A thin, flat printed part that binds loose resin and other debris
together in the resin tank for removal and disposal.
Cover The printer lid, made of a strong, orange-tinted material, blocks
exposure to the curing light and protects the resin from curing due
to ambient light.
Display assembly
The display assembly contains the touchscreen and the display
circuit board. A ribbon cable connects the display assembly to
the motherboard.
Display cable A flat, flexible cable connects the display assembly to
the motherboard.
Display PCB This circuit board, separated from the main motherboard, controls
the touchscreen.
Ethernet port The Form4B can connect to a network via Ethernet. The port is
connected to the motherboard and can be accessed from the
back of the machine.