FortiGate-200A, FortiGate-300A, FortiGate-400A, and FortiGate-500A FortiOS 3.0 MR4 Install Guide
30 01-30004-0268-20070712
Restoring the default settings Factory defaults
The FortiGate unit comes preconfigured with four protection profiles.
Restoring the default settings
You can revert to factory default settings and start over again if you mistakenly
change a network setting and are unable to recover from it.
Restoring the default settings using the web-based manager
To reset the default settings
1 Go to System > Status.
2 In the Unit Operation display, select Reset.
Restoring the default settings using the CLI
To reset the default settings, enter the following command:
execute factoryreset
Strict To apply maximum protection to HTTP, FTP, IMAP, POP3, and SMTP traffic.
You may not use the strict protection profile under normal circumstances but
it is available if you have problems with viruses and require maximum
screening.
Scan To apply antivirus scanning and file quarantining to HTTP, FTP, IMAP,
POP3, and SMTP content traffic.
Web To apply antivirus scanning and web content blocking to HTTP content
traffic. You can add this protection profile to firewall policies that control
HTTP traffic.
Unfiltered To apply no scanning, blocking or IPS. Use if you do not want to apply
content protection to content traffic. You can add this protection profile to
firewall policies for connections between highly trusted or highly secure
networks where content does not need to be protected.
Caution: This procedure deletes all changes you have made to the FortiGate configuration
and reverses the system to its original configuration, including resetting interface
addresses.
Note: If you want to restore factory default settings using the front control buttons and LCD,
see “LCD front control buttons” on page 24.
To Next Page
Loading...
