Document enhancements Scope
Document enhancements
The following document content is enhanced or changed since FortiWAN 4.0.1:
FortiWAN 4.2.1
l
A garbage character R at the leftmost position of the topic line "Define routing policies for an IPSec
VPN" in page 198 was removed.
FortiWAN 4.2.0
l
New page "Automatic addressing within a basic subnet" was added for the new features DHCP Relay
and static addressing by client identifier. Related pages "LAN Private Subnet", "Configurations for a
WAN link in Routing Mode" and "Configurations for a WAN link in Bridge Mode: Multiple Static IP"
were enhanced.
l
New topic "IPSec" and new page "Statistics > IPSec" were added for new feature IPSec. Related
pages "Log > View", "Log > Log Control", "How the Tunnel Routing Works" and "Tunnel Routing -
Setting" were enhanced.
l
Content of "Bandwidth Management" was updated for a behavior change - visibility to Tunnel Routing
traffic. A new page "Traffic Statistics for Tunnel Routing and IPSec" was added for this.
l
Content of "Administration" was updated in sections "Administrator and Monitor Password" and
"Configuration File" for updated features - allowing change personal password by Monitor account and
performing synchronization to slave unit after configurations are restored on master unit.
l
The description of the account "maintainer" in "Connecting to the Web UI and the CLI" was removed.
l
Content of "Optimum Route Detection", "DNS Proxy", "Configurations for VLAN and Port Mapping",
"Internal DNS", "Set DNS server for FortiWAN", "FortiWAN in HA (High Availability) Mode" and
"Inbound Load Balancing and Failover (Multihoming)" was enhanced.
FortiWAN 4.1.3
l
A section describing log format was added in "Log > View".
FortiWAN 4.1.2
l
Content of "Global Settings: IPv4 / IPv6 PTR Record" in "Inbound Load Balancing and Failover
(Multihoming)" was changed.
FortiWAN 4.1.1
l
Content was added to "Console Mode Commands" for the new CLI command shutdown.
l
Requirement of License Key was removed from section Firmware Upgrade in "FortiWAN in HA (High
Availability) Mode" and "Administration".
l
Two deployment scenarios were added to "Tunnel Routing > Scenarios".
l
Correspondent MIB fields and OIDs were added to "FortiWAN in HA (High Availability) Mode",
"Summary", "Administration" and "Network Setting > MIB fields for WAN links and VLANs".
l
Content of "SNMP" and "Notification" was enhanced.
l
Content of "Statistics > WAN Link Health Detection" was enhanced.
FortiWAN 4.1.0
l
Content was added to "Scope", "Default Port Mapping", "FortiWAN in HA (High Availability) Mode",
17 FortiWAN Handbook
Fortinet Technologies Inc.
To Next Page
Loading...
