Fortinet FortiWAN - Appendix A: Default Values; FortiWAN Log-ins; WAN Link Health Detection Default Values; Network default Values (FortiWAN 200 B)

Reports Settings Appendix A: Default Values
Appendix A: Default Values
In console, enter the command ‘resetconfig’, or on the Web UI select “Factory Default” to do a hard reset and restore
all settings to factory default.
When restored to factory default, accounts and passwords for access of CLI, Web UI and SSH login will also be reset
to:
FortiWAN Log-ins
< V4.0.x V4.1.0
Web-based Manager Default Adminstrator/1234 Adminstrator/1234
Monitor/5678 (read-only) Monitor/5678 (read-only)
admin/null (Fortinet default)
CLI Default Adminstrator/fortiwan Adminstrator/1234
admin/null (Fortinet default)
The Web UI login port will be restored to the default port 443.
FortiWAN also supports SSH logins. The interface for SSH login is the same as the console with identical username
and password.
WAN Link Health Detection Default Values
l System default values contain 13 fixed servers IPs for health detection.
l Values for all Port Speed and Duplex Settings will also be reset.
l All ports are restored back to AUTO state.
Network default Values (FortiWAN 200B)
Port 1: WAN
l WAN Link: 1
l IP: 192.168.1.1
l Netmask : 255.255.255.0
l IP in DMZ 192.168.1.2~192.168.1.253
l Default Gateway 192.168.1.254
l DMZ at Port 5
Port 2: WAN
l WANLink: 2
l IP: 192.168.2.1
FortiWAN Handbook
Fortinet Technologies Inc.
309