Log Notification
Notification
Two methods are provided to send out the notifications for important system events: E-mail and SNMP trap. Please
configure the settings for the methods and select the event type to notify.
E-Mail Settings
The table below summarizes the event notification mail setup:
SMTP Server SMTP Server
SMTP Port Specify the port (465 by default) that the SSL encrypted SMTP is using if the SSL
check box is checked. FortiWAN uses fixed port:25 for non-encrypted SMTP. This field
becomes ineffective if the SSL is unchecked.
SSL Check to enable SMTP transfers over SSL.
Account Authenticated account for the mail server
Password Authenticated password for the mail server
Mail From Sender
Mail To Receiver(s). Separate receivers with “,” or “.”.
Send Test E-mail Now Click the button to run test for the email settings above.
Note: If the SMTP Server is applied with a FQDN, then the DNS Server must be set in the Web UI System > Network
Settings > DNS Server (See "Set DNS server for FortiWAN").
SNMP Trap Settings
Event notification can also be sent via SNMP traps. These can only be sent if there is an existing SNMP manager for
receiving FortiWAN’s SNMP traps.
Destination IP The SNMP managing device IP
Community Name Community name
266 FortiWAN Handbook
Fortinet Technologies Inc.
To Next Page
Loading...
