Reports Bandwidth Usage
l Only one of the three statistics data (% Inbound Bytes, % Outbound Bytes, or % Total Bytes) will be
displayed in the statistics table depending on the primary sort column.
l This page and this table describe total traffic volume, not traffic rate. Data transferred are measured in
KBytes, MBytes or GBytes over the period of time selected.
l
Drill in (See "Drill In"):
l Clicking the magnifier icon located under the “Drill in” column in the statistics table allows you to perform an
additional ‘drill-down’ analysis on traffic for the selected Internal IP address, shown by In Class, Out Class,
WAN, Service, External IP, Internal Group, External Group and Traffic Rate (Trend) via the selected
Internal IP address:
l In Class – In Classes that are associated with this Internal IP address.
l Out Class – Out Classes that are associated with this Internal IP address.
l WAN – WAN links that are associated with this Internal IP address.
l Service – Services (L3-L7) that are associated with this Internal IP address.
l External IP – Any monitored external IP addresses that are associated with this Internal IP address.
l Internal Group – Any monitored internal IP group (set up under the Settings menu) where this Internal IP
address belongs to.
l External Group – Any monitored external IP group (set up under the Settings menu) that the external IP
addresses are associated with this Internal IP address.
l Traffic Rate: bandwidth distribution generated by this Internal IP address by the date range defined.
Traffic Rate
This report shows the statistics of traffic passed through FortiWAN by Traffic Rate.
Create a report for a specific day or over a range of dates (See "Create a Report").
Export reports and send reports through email (See "Export and Email").
Bandwidth Distribution:
l X axis: Time between 00:00 to 23:59 (of a selected date). Days from start to end if Date Range specified (max 90
days).
l Y axis: Bandwidth in Kbps or Mbps.
l Green indicates inbound data rate.
l Blue indicates outbound data rate.
l Clicking on Both, In or Out buttons at the right upper corner of the graph allows you to see bandwidth distribution in
different directions:
l Both: Displays both inbound and outbound bandwidth distribution.
l In: Displays only inbound bandwidth distribution.
l Out: Displays only outbound bandwidth distribution.
l Moving the mouse over the graph will display time, date and corresponding traffic distribution.
Statistics Table:
l List the average inbound and outbound traffic rate distributed by the date range defined. This is the numerical
presentation of the same information in the Bandwidth Distribution Charts.
l Time: The time periods or date ranges defined.
284 FortiWAN Handbook
Fortinet Technologies Inc.
To Next Page
Loading...
