Fortinet FortiWAN - Page 212

IPSec IPSec set up
Interface Name
wan1
Type
Physical Interface
Addressing mode
Manual
IP/Network Mask
10.12.136.180/255.255.255.0
VPN
Go to VPN > IPsec > Tunnels and click Create New.
Name
IPSec_to_FWN_P1
Select "Custom VPN Tunnel (No Template)" and click Next to configure the settings as follows:
Network
IP Version
IPv4
Remote Gateway
Static IP Address
IP Address
10.12.102.42
Interface
WAN1
Mode Config
Disable
NAT Traversal
Disable
Dead Peer Detection
Disable
Authentication
Method
Pre-shared key
Pre-shared key
12345
IKE
Version
V1
Mode
Main (ID protection)
Phase 1 Proposal
212 FortiWAN Handbook
Fortinet Technologies Inc.