Configuring Network Interface (Network Setting) How to set up your FortiWAN
Type] in [Basic Subnet]. Then enter 192.168.3.1 in [IP(s) on Localhost] and the netmask offered by ISP in [Netmask].
Note: FortiWAN assumes that IP addresses that are unlisted in [IP(s) on Localhost] are all in WAN.
[Basic Subnet]: Subnet in DMZ
This topology is frequently found where cluster hosts in IPv4 private subnet are located on the DMZ. In this example,
FortiWAN port5 has been mapped to DMZ port, with private IP 192.168.4.254. And subnet 192.168.4.X is located on
the DMZ as a whole. From UI, select [Subnet in DMZ] from [Subnet Type] in [Basic Subnet].
FortiWAN Handbook
Fortinet Technologies Inc.
81
To Next Page
Loading...
