Foscam C1 User Manual

12
Notes:
 We recommend you to choose to manually set the IP when you know some knowledge of the
network.
 It needs about 1 minute to connect the camera to your router.
7. After completing the setup wizard, you should press the Soft AP button for 3-5 seconds to cancel the
Soft AP connection mode, this is located on the back of your camera. The Network light begins to slowly
flash(once per second), it indicates that the wireless connection is successful.
8. Please make sure that the wireless device connect your laptop to the router which your camera has

Foscam C1 Specifications

General

Type	IP security camera
Placement supported	Indoor
Connectivity technology	Wired & Wireless
Form factor	-
Mounting type	Desk/Ceiling
Product color	Black
Maximum resolution	1280 x 720 pixels
Video formats supported	H.264
Minimum illumination	0 lx
Sensor type	CMOS
Optical sensor size	1/4 \
Motion sensor	Yes
Built-in HDD	No
Compatible memory cards	MicroSD (TransFlash)
Night vision distance	8 m
Wi-Fi standards	802.11g, Wi-Fi 4 (802.11n)
Cabling technology	10/100Base-T(X)
Networking standards	IEEE 802.11d, IEEE 802.11g, IEEE 802.11n
Ethernet interface type	Fast Ethernet
Ethernet LAN (RJ-45) ports	1
Power consumption (typical)	3 W
Sustainability certificates	RoHS
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	120 mm
Width	70 mm
Weight	170 g