Slow Flash every 1.0 second
Flashing every 0.4 seconds
Flashing every 0.2 seconds
C2
Front panel Rear panel
Front panel:
PIR:The PIR ( Passive Infrared ) is electronic devices which are used in some security alarm
systems to detect motion of an infrared emitting source, usually a human body.
Micro SD Card slot: Supports up to 64GB SD card for storing the video.
LAN: 10/100 Mbps RJ-45 port for wired connection
WPS: Push both WPS/Reset button on the camera and wireless router within 1 minute, the
camera will connect to the wireless router automatically, in WPS process, the light will be green
and blink every 0.4 seconds;
Reset: Push and hold the WPS/Reset button for more than 10 seconds to set the camera to
factory default, the light will be red and blink every 0.4 seconds;
Power: DC 5V/1A Power supply.
The flashing status of the Power light and Network light are shown in the following table.
Flashing(red) every 0.4 seconds
Slow Flash(green) every 1.0 second
Flashing every(green) 0.4 seconds
Flashing every(green) 0.2 seconds