Foxconn Renaissance - Onboard Device Configuration; Sas Controller

3
28
OnBoard Device Conguration
► 1394 Controller
This item is used to enable or disable the 1394 controller.
► Broadcom5786 Lan Controller
This item is used to enable or disable the onboard Broadcom5786 LAN controller.
► Broadcom5786 Lan BOOTROM
This item is used to enable or disable the onboard Broadcom5786 LAN boot optional ROM.
A LAN boot ROM lets you set up a diskless workstation on the network. By installing a boot
ROM in the network board, you can enable a client PC system on the network to be booted
remotely.
► SAS Controller
This item is used to enable or disable the SAS(Serial Attached SCSI) controller.
► JMicron 36x ATA Controller
This item is used to select the operating mode for JMicron 36x ATA controller. Setting values
are: [Disabled], [IDE Mode], [RAID + IDE Mode] and [AHCI + IDE Mode]. This item is in charge
of the ESATA ports on the back panel and the IDE connector on board.
► HDA Controller
This item is used to enable or disable the HD Audio Controller.
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
OnBoard Device Conguration
OnBoard Device Configuration Help Item
1394 Controller
Broadcom5786 Lan Controller [Enabled]
Broadcom5786 Lan
BOOTROM [Disabled] Enabled
SAS Controller [Enabled] Disabled
JMicron 36x ATA Controller [IDE Mode]
HDA Controller [Enabled]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]
Options