60
Next Generation Diagnostic Platform NT726TS User's Manual V1.0
11.2.2 Clone by Activation
This function allows user to bypass OBD II and automatically write in the
retrieved original sensor data to the Foxwell sensor T10. It is used after the
original sensor is triggered.
To perform Clone by Activation, user needs active the installed sensor firstly,
if succeed, the sensor ID will display.
Figure 11-10 Sample Clone by Activation Function Screen
Then put the Foxwell T10 sensor that need to be programmed close to the
device 0-20cm and sensors that not need to be programmed beyond 100cm.
To Next Page
Loading...
