The well, supports, grills and stainless steel
dishes should be cleaned with hot soapy
water. Do not use abrasive pads or cleaners,
as these may damage surfaces.
Small stainless steel parts may be cleaned
in a dishwasher.
Sweep out, or use a vacuum cleaner, to
remove any debris from the well.
Be sure to check that there is no debris in
the drain hole.
To access the cooling coil, remove the
screws that secure the fan deck, and then
lift the fan deck and remove the coil cover.
A Wet-and-Dry vacuum cleaner should be
used, since there is likely to be some water
in the bottom. Finally, wipe out the bottom
with a damp sanitized
cloth.
Caution: The cooling fins
are very sharp. Take extra care when cleaning this area. Do
not bend the fins over, as this would restrict the air flow and
degrade cabinet performance.
Do not pour water into the base, unless the well is
connected to a drain.
To avoid possible damage when replacing fan decks, be sure
that cables are not trapped by metal parts.
To Next Page
Loading...