IN-GNC03/4/5/6 - 9 - © Future Products Group
OPERATION
Configuration
GN SERIES REFRIGERATED WELL
-
OPERATION
The drop-in well consists of a main assembly,
with integral refrigeration equipment, in which
trays and gastronorm dishes of various sizes
can be mounted.
The control panel is located on the main
assembly, but since it is connected by a two
metre cable, it can be easily re-located onto the
joinery.
This versatile refrigerated well can be configured to display food in a variety of
ways:
On adjustable height trays, using dishes or platters
On trays of ice, for fresh fish or similar
In gastronorm dishes of various sizes
The operating temperature of the well is governed by a digital controller.
This is pre-set to maintain the correct chilled air temperature of 2°C to 4°C.
Care must be taken to load the well correctly, to ensure correct product
temperature.
Condensate water will be released during defrost cycles.
Ideally this should be routed to an external drain, but a removable container
could be used.
An integral boil-off unit is available, as an optional extra, at the time of ordering.
However, unless really good forced ventilation is provided, integral boil-
off trays are not recommended due to potential moisture damage to the
joinery.
An optional lighting gantry is available.
The well assembly has provision for easily mounting the gantry and is pre-wired
to supply power for the overhead LED lighting.
The lighting switch is on the gantry.
To Next Page
Loading...