Framery Q (UL) Meeting Maggie
2. Slide the threshold against the door frame.
Note: Make sure that the side seals are not between the threshold and the
door frame. Neatly cut the side frame seal to the correct length, if needed.
Note: Make sure that the side frame seals and the threshold seal do not
overlap. Neatly cut the threshold seal to the correct length, if needed.
Note: Make sure that the protective plastic on the aluminum frames is not
under the threshold. Peel back further, if needed.
3. Install the floor threshold with 5x50 screws (2 pcs).
Note: Make sure to install the screws to the middle of the screw holes.
Installation instructions
info@frameryacoustics.com
111
To Next Page
Loading...
