Franke A300 - Help with Problems Concerning Product Quality

Franke Kaffeemaschinen AG |
User manual A300 71
There are two different troubleshooting
methods:
– Method 1: Press and hold the red
button on the right-hand side of the
operator panel for 10 seconds to restart
– Method 2: Disconnect the coffee
machine from the power grid. Wait 1
minute before reconnecting the coffee
machine to the power grid. Briefly press
the red button on the right-hand side of
the operator panel to switch it on
Water level in water tank Residual substances or deposits on the Thoroughly clean and rinse out the water
not being detected water tank's internal wall tank
Troubleshooting 13
Error message/problem Possible cause
Measure
No milk or just milk foam Suction hose/milk line has a leak
Check the position of the spout insert and,
if necessary, clean it. SU05 cooling unit:
Check the O-ring on the suction hose
coupling. Check the suction hose and, if
necessary, replace it
Milk is not flowing correctly The milk spout was not installed
corout of the milk spout rectly when it was last cleaned
Start the coffee machine cleaning process,
and install the milk spout as per the
instructions on the touchscreen. The milk
spout is also part of the care kit – see Care
kit [ 53]
13.2.1 Restarting the machine
13.3 Help with problems concerning product quality
Problem
Possible causes
Possible remedy
Coffee tastes stale
Grind too coarse
Select a finer grind Setting the grind
coarseness
Too little coffee
Increase the amount of coffee Setting drinks
[ 33]
Temperature too low
Increase the temperature Setting drinks [
33]

The machine will restart.

The
start screen is displayed.