FMO 45 GN 81 / FMO 45 GN 86
– 18 –
EN
Cleaning Oven Glass
Lift by pressing on plastic latches on
left and right side as shown infigure
8and pulling theprofile toward yourself
asinfigure 9.
Glass isreleased after profile
isremoved as shown infigure 10.
Remove thereleased glass by pulling
toward yourself carefully. Outer glass
isfixed tooven door profile. You can
perform glass cleaning easily after glasses
are released. You can mount glasses back
by performing theoperations reversely
after cleaning and maintenance are
completed.
Ensure that profile isseated properly
inplace.
Fig. 8
Fig. 9
Fig. 10
Rack Positions
It isimportant toplace thewire grill into the
oven properly. Do not allow wire rack to touch
rear wall oftheoven. Rack positions are shown
inthenext figure. You may place a deep tray
orastandard tray inthelower and upper wire
racks.
Rack 4
4
3
2
1
Rack 3
Rack 2
Rack 1
Installing and removing wire racks
To remove wire racks, press theclips
shown with arrows inthefigure, first
remove thelower, and than theupper side
from installation location.
To install wire racks; reverse theprocedure
for removing wire rack.
Replacing Oven Lamp
WARNING: toavoid electric shock, ensure that
theappliance circuit isopen before changing
thelamp (having circuit open means
power isoff).
First disconnect thepower ofappliance
and ensure that appliance iscold.
Remove theglass protection by turning
as indicated inthefigure on theleft side.
Ifyou have difficulty inturning, then using
plastic gloves will help you inturning.
Then remove thelamp by turning, install
thenew lamp with same specifications.
Reinstall glass protection, plug thepower
cable ofappliance into electrical socket
and complete replacement. Now you can
use your oven.
To Next Page
Loading...
Need help?
General
