Franke Smart User Manual

– 19 –
FMO 45 GN 81 / FMO 45 GN 86
EN
MAINTENANCE AND REPAIR
Troubleshooting guide
You may solve theproblems you may encounter
with your product by checking thefollowing
points before calling thetechnical service.
Check Points
In case you experience aproblem about
theoven, first check thetable below and try
out thesuggestions.
Problem Possible Cause What toDo
Oven does not operate
Power supply not available Check for power supply
Oven stops during cooking
Plug comes out from thewall socket Re-install theplug into wall socket
Turns off during cooking
Too long continuous operation
Let theoven cool down after long
cooking cycles
Cooling fan not operating Listen thesound from thecooling fan
Oven not installed inalocation
with good ventilation
Make sure clearances specified in
operating instructions are maintained
More than one plugs inawall socket Use only one plug for each wall socket
Outer surface oftheoven
gets very hot
during operation
Oven not installed inalocation with good
ventilation
Make sure clearances specified in
operating instructions are maintained
Oven door isnot opening
properly
Food residues jammed between the door
and internal cavity
Clean theoven well and try to re-open
thedoor
Internal light isdim
ordoes not operate
Foreign object covering thelamp
during cooking
Clean internal surface oftheoven and
check again
Lamp might befailed
Replace with alamp with same
specifications
Electric shock when
touching theoven
No proper grounding
Make sure power supply isgrounded
properly
Ungrounded wall socket isused
Water dripping
Water orsteam may generate under certain
conditions depending on thefood being
cooked. This isnot afault oftheappliance
Let theoven cool down and than wipe
dry with acloth
Steam coming out from
acrack on oven door
Water remaining inside
theoven
The cooling fan continues
tooperate after cooking
isfinished
The fan operates for acertain period for
ventilation ofinternal cavity oftheoven
This isnot afault oftheappliance;
therefore you don’t have toworry
Oven does not heat
Oven door isopen Close thedoor and restart
Oven controls not correctly adjusted
Read thesection regarding operation of
theoven and reset theoven
Fuse tripped orcircuit breaker turned off
Replace thefuse orreset thecircuit
breaker. ifthis isrepeating frequently,
call anelectrician
Smoke coming out during
operation
When operating theoven for the first time
Smoke comes out from theheaters.
This isnot afault. After 2-3cycles, there
will beno more smoke
Food on heater
Let theoven tocool down and clean food
residues from theground oftheoven and
surface ofupper heater

Franke Smart Specifications

General

Energy Efficiency Class	A
Number of Functions	8
Voltage	220-240 V
Installation Type	Built-in
Color	Stainless Steel
Control Type	Electronic
Cooling Fan	Yes
Door	Double Glazed
Child Lock	Yes
Timer	Yes
Type	Built-in
Frequency	50/60 Hz