Frecon PV100-2S-2.2B - User Manual

PV series Solar Pumping Inverter
- 1 -
Preface
PV200 special inverters are developed for power supply of water pumps, based on the core
control arithmetic of FR200 vector control inverters, combined with the control requirements of PV
water pump application. The function of maximum power tracking, dormant at weak light, wake up at
strong light, high water level dormant, under-load pre-warning and other control protection functions
can ensure normal operation of water pumps according to the customers’ requirements to switch to the
grid power supply.
Please refer to this manual to commission the inverter, product maintenance refer to FR200 user
manual.
IMPORTANT NOTES
◆To illustrate the details of the products，pictures in this manual based on products with outer
casing or safety cover being removed. When using this product, please be sure to well install
outer casing or covering by the rules, and operating in accordance with the manual contents.
◆The illustrations in this manual are for illustration only and may vary with different products
you have ordered.
◆The company is committed to continuous improvement of products, product features will
continue to upgrade, the information provided is subject to change without notice.
◆If there is any questions when using, please contact our regional agents or our customer
service center:(+86-0755-33067999)
◆For other products, please visit our website. http://www.frecon.com.cn

Summary

Preface

Introduction to PV200 Series Solar Pumping Inverter

Introduction to the PV200 series solar pumping inverter and its capabilities.

Chapter One Product Overview

1.1 Name Plate

Explanation of the information presented on the inverter's name plate.

1.2 Product Specifications

Electric specifications for AC220V and DC310V input products.

1.3 Dimension Drawing

Visual representation and dimensions for product installation.

Chapter Two Commissioning Guide

2.1 PV Panel Power Supply Commissioning

Wiring and setup procedures for using PV panels as the power source.

2.2 Grid or Generator Power Supply Wiring

Wiring diagrams for connecting the inverter to grid or generator power.

2.3 Wiring Between VFD and Single Phase Motor

Technical guidance on wiring the inverter to single-phase motors.

2.4 Product Terminal Configuration

Detailed breakdown of the inverter's main and control circuit terminals.

Chapter Three Function Parameters

3.1 Basic Function Parameters

Explanation of essential system and frequency-related function parameters.

3.2 H00 Group: PV Pump Special Set

In-depth explanation of the H00 group function codes for PV pump special settings.

Chapter Four Troubleshooting and Countermeasures

Err01 Acceleration Overcurrent

Details reasons and troubleshooting steps for acceleration overcurrent faults.

Err04 Acceleration Overvoltage

Troubleshooting for acceleration overvoltage faults, including causes and solutions.

Err11 Motor Overload

Information on motor overload faults, parameters, and inverter selection.

Err29 Hardware Overcurrent

Troubleshooting for hardware-detected overcurrent, including parameter settings.

Frecon PV100-2S-2.2B Specifications

General

Brand	Frecon
Model	PV100-2S-2.2B
Category	Inverter
Language	English